242-22 Attachment - RFP Ginny Duenkel Underwater Lighting Improvements.pdf

2 Troubleshooting Use the following tips to help to resolve problems that might occur while operating the LED light. Problem Cause/Action The light will not illuminate, Check the ground fault wiring and reset if necessary. Light does not function properly. | Check the light wiring connection to the junction box at the pool side and to the AC power switch. Be sure that there is proper AC power applied to the light. IntelliBrite Pool and Spa White LED Light Installation The following describes how to install the IntelliBrite pool and spa white LED light fixture. Read through pages 2 through 7 before starting the installation procedure. BEFORE STARTING: The following steps 1-6 (page 3-4) describe the tasks that must be completed by the electrician before the IntelliBrite light fixture is installed. See Figure 1 diagram. Be sure that the pool or spa meets the requirements of the current National Electrical Code (N.E.C.) Article 680-22 and all local codes and ordinances. A licensed or certified electrician must install the electrical system to meet or exceed those requirements before the underwater light is installed. Some of the requirements of the National Electrical Code which the pool's electrical system must meet are as follows: * The lighting circuit has a Ground Fault Circuit Interrupter (GFCI) for line voltage models, and has an appropriately rated circuit breaker. * — The Junction Box (or, for 12 volt models, the low voltage transformer) is located at least 8 inches above the maximum water level of the pool and at least 48 inches from the edge of the pool; see Figure 1. * The light fixture and all metal items within 5 feet of the pool are properly electrically bonded. * The wet niche is properly installed so that the top edge of the underwater light’s lens is at least 18 inches below the surface of the water in the pool; see Figure 1. (Not more than 20" depth in Canada.) * The wet niche is properly electrically bonded and grounded via the No. 8 AWG ground connector located at the rear of the niche; see "Figure 1. TntelliBrite® Pool and Spa White LED Light Installation and User’s Guide