242-22 Attachment - RFP Ginny Duenkel Underwater Lighting Improvements.pdf

Note: The pool or spa electrical system can be verified with a Pool and Spa Electrical Qualification Test Kit. The test kit is available from Pentair Water Pool and Spa®. The electrical system inspection using this kit must be performed by trained and certified personnel. To be certain that the pool or spa electrical system meets all applicable requirements, the electrician should also consult the local building department. Use only Pentair Water Pool and Spa wet niches to insure proper bonding and grounding connections. Installing the IntelliBrite White LED light (after electrical requirements are met) 1. Feed cord through conduit to Junction Box, leaving at least four (4) feet of cord at the light fixture to coil around the light; see Figure 1. The four (4) feet of cord around the light allows the light to be serviced after the pool is filled with water. | 48" | min. | To GFCI, Circuit <= 2 Breaker and 4" min. 8" min. Junction Box or Low Power Source. ay Figure 1. Voltage Transformer, to the max. water level of the pool. Rigid 118" min, to top of Lens, Conduit #8 AWG Ground Connector bonding is located at rear of niche. back around niche to allow for a compacted plaster seal. 11.50" Coil 4 ft. of light cable around fixture. } Concrete must be cut Cut the cord at the Junction Box, leaving at least six (6) inches of cord to make connections. Strip back six (6) inches of the outer cord jacket to expose the three insulated wires (be careful not to damage the insulation on the three (3) inner wires). Connect all three (3) wires to the corresponding circuit wires in the Junction Box and secure the Junction Box cover in place. IntelliBrite® Pool and Spa White LED Light Installation and User's Guide