242-22 Attachment - RFP Ginny Duenkel Underwater Lighting Improvements.pdf

9. INSTALLING THE INTELLIBRITE LED LIGHT WITH NEW GASKET: Install a new gasket (P/N 79101600, see page 10) during reassembly of the IntelliBrite LED light. A NEW LENS GASKET MUST BE USED EACH TIME THE LIGHT IS REASSEMBLED. 10. Clean the inside surface containing the four mounting studs with isopropyl alcohol. Be sure to keep the underside of the new IntelliBrite LED assembly clean. Clean this surface before installing the light assembly 11. Connect the IntelliBrite LED light plug to the connector in the light housing. Lower the LED light assembly into the light housing. Be sure that there are no wires caught between the housing and the back of the light assembly. 12, Orientate the light assembly so that the word “Pentair” on the circuit board is positioned at the top (where cable exits) as shown below. Top of light housing Cable. where cable exits — The word “Pentair” onthe circuit board _ is positioned at the top ~ Retaining nut (4x) 13. With the housing resting on its base, carefully align the four screws holes of the light assembly and the housing base. Using a %" nut driver, secure the light assembly in place with the four (4) retaining nuts. IntelliBrite® Pool and Spa White LED Light Installation and User's Guide