242-22 Attachment - RFP Ginny Duenkel Underwater Lighting Improvements.pdf

14. Install the new gasket onto the lens: a) With the light housing resting on its base, place the lens then the gasket on top of the light housing. b) Place the face ring on top of the gasket. Make sure that the lens and gasket are centered correctly on the light housing. c) Aligning the face ring and lens: Align the face ring and lens so that the letter “O” in the word “TOP” (and the small arrow above it) on the surface of the lens points to the pilot screw hole on the face ring. d) Aligning the lens position with the LEDs: While looking through the front of the lens, slightly rotate the lens until the vertical lines on the lens are in focus with the four (4) rows of LEDs below, 5 Align letter “O” in the word “TOP” on lens with pilot screw hole on face ring Align vertical line ‘on lens with rows of LEDs under lens 15. With the hook ends of the circular uni-tension clamp pointing down, spread the clamp and place it in the “U” recesses of the locking levers. Be sure the hook ends of the clamp are located between the pair of locking levers as shown below and that the wire clamp is properly engaged with all of the lock levers. 16. Place a cloth on the ground to protect the lens. Turn the light over so the lens is resting on the cloth. Be sure the orientation of the wire clamp and the bolt connection is positioned at 45°. 17. Tighten the bolt and nut until the distance between the ends of the clamp equals %-inch or less. Pilot Screw 1/4" or Less Pilot Screw Position wire clamp nut and bolt Tighten nut and bolt so that distance between about 45° between Pilot screw ends of clamp equals %-inch or less.. and lock levers. IntelliBrite® Pool and Spa White LED Light Installation and User’s Guide