242-22 Attachment - RFP Ginny Duenkel Underwater Lighting Improvements.pdf

16 Replacing the IntelliBrite Pool or Spa White LED Light Assembly (in an existing pool or spa) Risk of Electrical Shock or Electrocution! This underwater light must be installed by a licensed or certified electrician or a qualified pool professional in accordance with the National Electrical Code and all applicable local codes and ordinances. Improper installation will create an electrical hazard which could result in death or serious injury to pool users, installers or others due to electrical shock, and may also cause damage to property. ADANGER | 72 ‘ Always disconnect the power to the pool light at the circuit breaker before servicing the light. Failure to do so could result in death or serious injury to serviceman, pool users or others due to electrical shock. Verify that the pool and spa meets the requirements of the current National Electrical Code and all local codes and ordinances. A licensed or certified electrician must install the electrical system to meet or exceed those requirements before the underwater light is installed. Some of the requirements of the National Electrical Code which the pool's electrical system must meet are as follows: * The lighting circuit has a Ground Fault Circuit Interrupter (GFCI) for line voltage models, and has an appropriately rated circuit breaker. * — The Junction Box (or, for 12 volt models, the low voltage transformer) is located at least eight (8) inches above ground level and at least 48 inches from the edge of the pool; see Figure 1 on page 3. ¢ The light fixture and all metal items within five (5) feet of the pool are properly electrically bonded. * — The wet niche is properly installed so that the top edge of the underwater light’s lens is at least 18 inches below the surface of the water in the pool; see Figure 1 on page 3. * The wet niche is properly electrically bonded and grounded via the No. 8 AWG ground connector located at the rear of the niche; see Figure 1. Note: The poo! and spa electrical system can be verified with a Pool and Spa Electrical Qualification Test Kit. The test kit is available from Pentair Water Pool and Spa. The electrical system inspection using this kit must be performed by trained and certified personnel. *. To be certain that the pool's electrical system meets all applicable requirements, the electrician should also consult the local building department. « — Use

d by trained and certified personnel. *. To be certain that the pool's electrical system meets all applicable requirements, the electrician should also consult the local building department. « — Use only Pentair Poo! Products® wet niches to insure proper bonding and grounding connections. IntelliBrite® Pool and Spa White LED Light Installation and User’s Guide