242-22 Attachment - RFP Ginny Duenkel Underwater Lighting Improvements.pdf

17 Replacing the IntelliBrite Pool or Spa White LED light (after electrical requirements are met) The following installation instructions describe how to install the IntelliBrite white pool and spa LED light assembly after completing the LED light engine removal and replacement procedures. Refer to: IntelliBrite Pool White LED Light Removal and Installation instructions, on page 5. ' IntelliBrite Spa White LED Light Gasket, Face Ring and Lens Removal and Installation instructions, on page 11. Failure to bring the pool or spa’s electrical system up to code requirements before installing the underwater light will create an electrical hazard which could result in death or serious injury to pool users, installers, or others due to electrical shock, and may also cause damage to property. WARNING! Switch off main electrical switch or circuit breaker, and the switch which operates the IntelliBrite underwater light. To remove light fixture assembly from the pool. Remove the special bronze pilot screw at top of face ring. Remove the IntelliBrite light assembly from the niche and place it on the deck. Remove Junction Box cover, disconnect the light fixture wires, and pull the cord through the conduit. Feed the new light fixture cord through the conduit from the niche to the Junction Box. Note: Depending on the length of the conduit, special tools may be required to pull the cord through the conduit. Leave at least four (4) feet of cord to coil around the light fixture; see Figure 1 on page 3. This four (4) feet of cord coiled around the light allows the light to be serviced after the pool is filled with water. Cut the cord at the Junction Box, leaving at least size (6) inches of cord to make connections. Strip six (6) inches of the outer cord jacket from the cord to expose the three insulated wires — Be careful not to damage the insulation on the three inner wires. Connect all three wires to the corresponding circuit wires in the Junction Box (black wire to power, white wire to common, and green wire to ground) and secure the Junction Box cover in place. TntelliBrite® Pool and Spa White LED Light Installation and User’s Guide