146-25 Ex. A to Easement Agreement-46 Mount Pleasant Avenue.pdf

INSTALL (2) CHARGE POINT EXPRESS 250 LEVEL III CHARGING STATIONS ON CONCRETE PAD (TYP OF 2) INSTALL (2) BOLLARDS 3'-0 ON CENTER PER CHARGER (SEE BOLLARD DETAIL) T ROUTE (1)3" & (1)3 4 PVC-SCH.40" FBELOW GRADE OR SHARED POWER AND COMMUNICATION INSTALL EV CHARGER SIGN (TYP OF 2) ROUTE (1) 2" PVC-SCH.40 BELOW GRADE TO CHARGERS INSTALL (UG) UNDERGROUND ENCLOSURE DRIVEWAY ROUTE 2" PVC-SCH.40 BELOW GRADE TO CHARGER #1 ROUTE 2" PVC-SCH.40 BELOW GRADE TO CHARGER #2 EV PARKING SLOT #1 EV PARKING SLOT #2 EXISTING PARKING SLOT EXISTING PARKING SLOT EXISTING PARKING SLOT EXISTING PARKING SLOT EXISTING PARKING EXISTING PARKING SLOT EXISTING PARKING SLOT WEATHER TIGHT CONDUIT PENETRATION JWP ROUTE FEEDERS TO DISCONNECT SWITCHES THROUGH THE TOP AND BOTTOM WIREWAYS (2) 480 VOLTS 100 AMP CIRCUIT BREAKER TYPE DISCONNECT SWITCH IN NEMA 1 ENCLOSURE (MIN.18 KAIC) PENETRATE 2" CONDUIT THROUGH WALL ROUTE 2" CONDUIT ALONG WALL. (ENTIRE LENGTH FROM TRANSFORMER TO THROUGH SHOULD NOT BE MORE THAN 25'-0) NEW 150.0 KVA STEP DOWN TRANSFORMER PRIM: 480 VOLTS SEC: 120/208 VOLTS ROUTE 4" CONDUIT ON WALL 400 3 CONNECT NEW FEEDER TO EXISTING 400 AMP CIRCUIT BREAKER IN PANEL SECTIONED MAIN DISTRIBUTION PANEL 'MDP-1' EXISTING 120/208 VOLTS 1000 AMPS SWITCHBOARD WITH SECTIONED MAIN DISTRIBUTION PANEL 'MDP-1' M EXISTING GAS PIPING LOCATION OF EXISTING GAS METER AND PIPINGS (ELECTRICAL FEEDS SHALL CIRCUMNAVIGATE AROUND PIPINGS AND OTHERS) UTILITY ROOM PARKING/ DRIVEWAY AREA DRIVEWAY MAGNETIC FOR REVIEW ONLY, NOT FOR CONSTRUCTION 12.20.2024 NOTE: CONTRACTOR MUST REFER TO THE MANUFACTURER FOR FULL ELECTRICAL DETAILS, INSTALLATION MANUAL AND SHALL BE RESPONSIBLE FOR FULL INSTALLATION TO COMPLETE THE SYSTEM. CHARGER SCHEDULE MANUFACTURER MANUFACTURER & EQUIPMENT FEATURES KW VOLTS PHASE AMPS BREAKER CONDUCTOR SIZE & COUNT GROUND SIZE & COUNT CONDUIT SIZE & TYPE CHARGE POINT CHARGE POINT: CPE-250 EXPRESS 250 LEVEL III (1) CCS1 VEHICLE CONNECTOR, (1) CHADEMO VEHICLE CONNECTOR 62.50 480 3Ø 75 100 1 #2/0 2" PVC - SCH.40 EXISTING MAIN DISTRIBUTION PANEL 'MDP-1' 120 / 208 VOLT 3Ø, 4 WIRE CKT LOCATION / ITEM KVA WIRE GND BREAKER BREAKER GND WIRE KVA LOCATION / ITEM CKT 1 EXISTING LOAD (HVAC-2) 250 400 150.0 KVA TRANSFORMER (PRIMARY VOL: 208 VOLTS SECONDARY:480 VOLTS 2 3 #2/0 #400KCML 125.0 4 5 3 3 6 7 EXISTING LOAD ('2A') 125 100 EXISTING LOAD ('1A') 8 9 10 11 3 3 12 13 EXISTING LOAD (ELEVATOR) 100

150.0 KVA TRANSFORMER (PRIMARY VOL: 208 VOLTS SECONDARY:480 VOLTS 2 3 #2/0 #400KCML 125.0 4 5 3 3 6 7 EXISTING LOAD ('2A') 125 100 EXISTING LOAD ('1A') 8 9 10 11 3 3 12 13 EXISTING LOAD (ELEVATOR) 100 70 EXISTING LOAD (KITCHEN) 14 15 16 17 3 3 18 19 EXISTING SPARE 70 70 EXISTING SPARE 20 21 22 23 3 3 24 25 EXISTING SPARE 30 20 EXISTING SPARE 26 27 28 29 3 3 30 31 SPACE 20 EXISTING SPARE 32 33 34 35 3 36 EXISTING PANEL WITH 36 POLES HAS 1000 AMP MLO. ALL HVAC EQUIPMENT AND MOTOR LOADS SHALL HAVE HACR TYPE CIRCUIT BREAKERS EST. EXISTING LOAD: 120.0 KVA NEW LOAD: 125.0 KVA EST. TOTAL LOAD: 245.0 KVA E-1 WALTER W. SPENCER JR. CONSULTING ENGINEERS Drawing No: Bryan Electric Co. Inc. ELECTRICAL SERVICE TO EV CHARGING STATIONS EV CHARGING STATION FOR OLD WEST ORANGE LIBRARY AT 66 MAIN STREET W.ORANGE, NJ 08104 Project Title: 12/23/2024 Date: AS SHOWN Scale: Drawn by: Drawing Title: AA App by: - www. bryanelectricco.com NJ Lic. # 6222 Studio Park 1800 East State St., Suite 150C Hamilton, NJ 08609 609-393-8325 107 Coles Rd. Blackwood, NJ 08012 Phone: (856) 374-0056 Fax: (856) 374-1011 1 E-1 EV CHARGER POWER PLAN SCALE: 1/4" = 1'-0 2 E-1 KEY PLAN NO SCALE AREA OF WORK OLD WEST ORANGE LIBRARY MT. PLEASANT AVE. MAIN ST. EV CHARGER POWER PLAN, EQUIPMENT SCHEDULE & KEY PLAN 3 #2 (MIN.)

PARKING AREA CONCRETE PAD/FOOTING BELOW CHARGER (TYP PER PEDESTAL) 6 #1 THWN 1 #8 GROUND 2" PVC-SCH.40 CONDUIT INSTALL (UG) UNDERGROUND ENCLOSURE 2'-0 MIN. 5'-0 MIN. ELECTRIC VEHICLE PARKING ONLY WEATHER TIGHT CONDUIT PENETRATION WEATHER PROOFED JUNCTION BOX OR CONDULET INSTALL CHARGE POINT EXPRESS 250 LEVEL III CHARGING STATION ON CONCRETE PAD WP 100 3 100 3 400 3 1000 3M EXISTING 120/208 VOLTS 1000 AMPS SWITCHBOARD WITH SECTIONED MAIN DISTRIBUTION PANEL 'MDP-1' CONNECT NEW FEEDER TO EXISTING 400 AMP CIRCUIT BREAKER IN PANEL NEW 150.0 KVA STEP DOWN TRANSFORMER PRIM: 120/208 VOLTS SEC: 277/480 VOLTS 3 #600 KCMIL THHN 1 #2/0 GROUND 4" CONDUIT TOP WIREWAY 3 #1 THHN 1 #8 GROUND 2" CONDUIT 480 VOLTSD 100 AMP CIRCUIT BREAKER TYPE DISCONNECT SWITCH IN NEMA 1 ENCLOSURE (MIN. 18 KAIC) BOTTOM WIREWAY ELEC RM. 6 #1 THWN 1 #8 GROUND 2" CONDUIT 4 #4/0 XHHW-2 3" PVC-SCH.40 CONDUIT FOR POWER SHARING (1) CAT- 5E CABLE 3 4" PVC-SCH.40 CONDUIT INSTALL EV CHARGER SIGN ON PEDESTAL FOR EACH EV PARKING SPOT (TYP OF 2) U-CHANNEL SIGN POST 25'-0 MAX. J 6 #1 THHN 1 #4 GROUND 2" CONDUIT NOTE: 1. MARKING TAPE SHALL BE INSTALLED WHERE CONDUIT IS INSTALLED WITH OPEN TRENCH. 2. MARKING TAPE SHALL NOT BE INSTALLED WHERE CONDUIT IS INSTALLED WITH HORIZONTAL DIRECTIONAL DRILL OPEN TRENCH 12" ELECTRICAL CONDUITS GRADE DETECTABLE UNDERGROUND MARKING TAPE, C.H. HANSEN #16635, RED, 6" WIDE, STATING "CAUTION BURIED ELECTRICAL LINE BELOW". 24"-0" MINIMUM* * 24" MINIMUM FOR OPEN TRENCH UNDER ROADWAY. 18" MINIMUM FOR OPEN TRENCH NOT UNDER ROADWAY 15"(MIN.)3'-0" EXISTING PAVING TOTALLY ENCASE BOLLARD IN CONCRETE @3000 PSI 3'-0" FILL BOLLARD WITH CONCRETE & ROUND OFF AT TOP. 4" SCHEDULE 40 GALVANIZED STEEL PIPE, 6'-0 LONG, PAINTED 'TRAFFIC YELLOW' ELECTRICAL SPECIFICATIONS 1. THE WORK SHALL INCLUDE ALL LABOR, MATERIALS, AND SERVICES REQUIRED TO COMPLETE THE ELECTRICAL INSTALLATION. 2. THE CONTRACTOR SHALL MAKE ALL NECESSARY ARRANGEMENTS TO SECURE THE ELECTRICAL PERMIT. THE OWNER SHALL PAY ALL UTILITY COMPANY CHARGES REQUIRED TO SECURE SAME. 3. ELECTRICAL DRAWINGS ARE DIAGRAMMATIC AND INTENDED TO SHOW GENERAL POWER LAYOUTS. 4. CONTRACTOR SHALL CALL (800) 272-1000 (NJ ONE CALL) FOR MARK-OUT OF ALL UNDERGROUND UTILITIES AND SERVICES PRIOR TO COMMENCING ANY OUTDOOR WORK. 5. ALL ELECTRICAL WORK SHALL BE INSTALLED IN ACCORDANCE WITH THE LATEST EDITION OF THE NEW JERSEY UNIFORM CONSTRUCTION CODE AND

UNDERGROUND UTILITIES AND SERVICES PRIOR TO COMMENCING ANY OUTDOOR WORK. 5. ALL ELECTRICAL WORK SHALL BE INSTALLED IN ACCORDANCE WITH THE LATEST EDITION OF THE NEW JERSEY UNIFORM CONSTRUCTION CODE AND ALL APPLICABLE SECTIONS OF THE 2020 NATIONAL ELECTRICAL CODE. 6. ADJUSTMENT FACTORS FOR MORE THAN 3 CURRENT CARRYING CONDUCTORS IN A CONDUIT AND OTHERS SHALL BE APPLIED AS PER NATIONAL ELECTRICAL CODE #310.15(B). 7. ROUTING OF CONDUITS SHOWN IS FOR DESIGN PURPOSES ONLY. CONTRACTOR SHALL DETERMINE FINAL ROUTING IN FIELD. 8. ALL UNDERGROUND CONDUITS INSTALLATION MUST MAINTAIN MINIMUM 2'-0. PATCH, REPAIR & RESTORE CONCRETE/ASPHALT PAVEMENT, YARD AND OTHERS UPON COMPLETION OF WORK. 9. CHARGERS AND OTHERS SHOWN ON DRAWINGS ARE ESTIMATED LOCATIONS ONLY, PRIOR TO INSTALLATION, CONTRACTORS MUST VERIFY FIELD CONDITION AND FINAL LOCATION PRIOR TO INSTALLATION. 10. CONTRACTOR SHALL MAKE ALL NECESSARY ARRANGEMENTS TO MAINTAIN THE BUILDING ELECTRICAL SERVICE AT ALL TIMES. PERIODS OF ELECTRICAL SHUT DOWN SHALL BE COORDINATED WITH OWNER AT LEAST 48 HOURS IN ADVANCE. 11. GROUNDING SHALL BE PROVIDED IN ACCORDANCE WITH THE REQUIREMENTS OF THE NATIONAL ELECTRICAL CODE, THE UTILITY COMPANY, AND ALL AUTHORITIES HAVING JURISDICTION. 12. WIRING METHODS SHALL INCLUDE SCHEDULE 40 PVC &/OR HDPE BELOW GRADE, RIGID METAL CONDUIT, SCHEDULE 80 PVC OUTDOORS WHERE EXPOSED, ELECTRICAL METALLIC TUBING (EMT) AND METAL-CLAD CABLE INDOORS. ALL UNDERGROUND WIRING TO MEET NEC TABLE 300.5 13. MINIMUM WIRE TYPE SHALL BE TYPE "THW" OR "THHN" #12 COPPER AND 3/4 INCH MINIMUM CONDUIT. 14. VOLTAGE DROP SHALL NOT EXCEED THAT OUTLINED IN THE NATIONAL ELECTRICAL CODE #210.19(A). 15. ALL PANELS AND JUNCTION POINTS SHALL BE PERMANENTLY LABELED. 16. CONTRACTOR TO FURNISH AND INSTALL PULL BOXES, HAND HOLES, JUNCTION BOXES, ETC. REQUIRED TO PROPERLY ACCESS ALL CONNECTIONS. 17. ALL PENETRATIONS OF RATED WALLS AND FLOORS SHALL BE SEALED WITH U.L. APPROVED FIRE-STOPPING MATERIAL. 18. NUMBERING OF CIRCUITS ON DRAWING IS FOR CONVENIENCE ONLY AND BEARS NO RELATION TO USE OF PARTICULAR CIRCUIT BREAKERS IN PANEL BOARDS. LOADS SHALL BE BALANCED AND BREAKERS SHALL BE ARRANGED IN LOGICAL OPERATING SEQUENCE. 19. ALL ELECTRICAL DEVICES SHALL BE APPROVED BY A RECOGNIZED TESTING LABORATORY AND SHALL BEAR LABEL OF THE SAME. 20. CONTRACTOR MUST FOLLOW MANUFACTURER'S INSTALLATION PROCEDURE AND PROVIDE NECESSARY COMPONENTS TO

ICAL DEVICES SHALL BE APPROVED BY A RECOGNIZED TESTING LABORATORY AND SHALL BEAR LABEL OF THE SAME. 20. CONTRACTOR MUST FOLLOW MANUFACTURER'S INSTALLATION PROCEDURE AND PROVIDE NECESSARY COMPONENTS TO COMPLETE THE ENTIRE CHARGING STATION SYSTEM. 21. FURNISH ROUGH WIRING AND FINAL ACCEPTANCE CERTIFICATE FROM AUTHORITY PERFORMING ELECTRICAL INSPECTION. 22. CONTRACTOR SHALL REMOVE CONSTRUCTION DEBRIS FROM PREMISES AT THE END OF EACH DAY. UPON COMPLETION OF THE THE WORK, CONTRACTOR SHALL BROOM CLEAN AREA OF CONSTRUCTION. ALL DAMAGED SURFACES INCLUDING DRIVEWAY, SIDEWALKS, AND OTHER PAVEMENTS SHALL BE REPAIRED, AND REFINISHED AT THE END OF CONSTRUCTION PERIOD. SHORT CIRCUIT CALCULATION: TRANSFORMER SIZE 150 KVA PHASE 3Ø VOLTAGE (L-L) 480 VOLTS FULL LOAD AMPERES 180 AMPS %Z (AS PER NAMEPLATE LABEL) 4.81 %* %Z TOLERANCE 10 % CALCULATED LET THRU CURRENT 4,168 AMPS MINIMUM AIC RATING: 22,000 AMPS * (Z =TRANSFORMER IMPEDANCE) E-2 PANEL SCHEDULE, SHORT CIRCUIT CALCULATION, SPECIFICATION & DETAILS WALTER W. SPENCER JR. CONSULTING ENGINEERS Drawing No: Bryan Electric Co. Inc. ELECTRICAL SERVICE TO EV CHARGING STATIONS EV CHARGING STATION FOR OLD WEST ORANGE LIBRARY AT 66 MAIN STREET W.ORANGE, NJ 08104 Project Title: 12/23/2024 Date: AS SHOWN Scale: Drawn by: Drawing Title: AA App by: - www. bryanelectricco.com NJ Lic. # 6222 Studio Park 1800 East State St., Suite 150C Hamilton, NJ 08609 609-393-8325 107 Coles Rd. Blackwood, NJ 08012 Phone: (856) 374-0056 Fax: (856) 374-1011 1 E-2 ELECTRICAL SINGLE LINE DIAGRAM NO SCALE 5 E-2 UNDERGROUND FEEDER DETAILS NO SCALE 6 E-2 BOLLARD DETAILS NO SCALE 7 E-2 EV CHARGER PARKING SIGN NO SCALE DIMENSIONS: CPE-250 NO SCALE 2 E-2 CONDUIT TEMPLATE: CPE-250 NO SCALE 4 E-2 FOOTING / PAD DETAILS: CPE-250 NO SCALE 3 E-2 CONDUIT 2" PVC-SCH.40 1 #8 GROUND 3 #2 THWN