04_AECOM_Environmental Report_Final

Performance Test Report for Wood Fired Meat Smoker Project number: 89735150 2. Summary and Discussion of Results 2.1 Results Summary This section presents a detailed summary of the PM and PAH emissions results obtained during the performance test completed for the Wonder Meat Smoker on August 6 and August 7, 2024. As previously discussed in Section 1.0, three (3) test runs were completed for the purpose of quantifying PM and PAH emissions. Performance testing was performed while the meat smoker was operating at the maximum achievable load condition while combusting wood fuel. Table 2-1 provides a summary of the emissions results for the testing program. Note that Run 2 failed the past-leak check on the Method 5/202 train. As a result, Run 2 was voided, and an additional Run 4 was conducted to collect three representative samples. The remainder of this section provides summaries of the test results for each measured parameter. 2.44 Particulate Matter Results — Exhaust Stack As shown in Table 2-1, filterable PM (FPM) concentrations in units of grains per dry standard cubic foot (gr/dsef) averaged 0.0024 gr/dsef during the emissions testing. Concurrent FPM mass emission rates averaged 0.011 pounds per hour (Ib/hr). Condensable PM (CPM) concentrations averaged 0.0035 gr/dsef during the emissions testing. Concurrent CPM mass emission rates averaged 0.016 pounds per hour {Ib/hr). Total PM (TPM) concentrations averaged 0.0058 gr/dscf during the emissions testing. TPM mass emission rates averaged 0.027 pounds per hour (lb/hr). 2.1.2 Polycyclic Aramatic Hydrocarbons — Exhaust Stack PAH concentrations for individual compounds in units of nanograms per dry standard cubic foot and mass emission rates averaged in pounds per hour (Ib/hr) are presented in Table 2-2. AECOM 241